Possible to 3D-Print Replacement Mark I-II-III-IV EQ Knobs?

Post Boogies for sale and wanted.
No dealers please.

Moderators: Guitarzan, Grandor, ned, Platypus

Post Reply
horde5150
Bottle Rocket
Posts: 1
Joined: Tue Mar 04, 2014 2:37 pm

Possible to 3D-Print Replacement Mark I-II-III-IV EQ Knobs?

Post by horde5150 » Tue Mar 04, 2014 2:56 pm

I was wondering if anyone out in Boogieland has a 3D Printer, and thinks it may be possible to reprint the long-lost right-angle EQ knobs that so many of us may be missing from the older Pre-Mark V era.

Or, does it seem like something easier done with molding(moulding)/casting?

I realize it won't be "original", but I'm sure it would look better than "missing".

User avatar
MichaelC4
Mark III
Posts: 215
Joined: Sun Dec 26, 2010 10:26 pm
Location: Louisville, KY

Re: Possible to 3D-Print Replacement Mark I-II-III-IV EQ Kno

Post by MichaelC4 » Tue Mar 04, 2014 3:09 pm

Why not buy a new set from Mesa/Boogie?
http://mesa.stores.yahoo.net/greqslkn.html
Quad 295, Studio Pre 50/50, 50Cal+, Racktifier
4x12 halfbacks- 3 Top, 3 Bottom & 3 Road Ready
Lefty
Jackson- KV2, DKA
Gibson- Faded Flying V & SG, SG-1, SGJ
Dean- Z79
Schecter- Hellraiser C7
BC Rich- Mockingbird ST
Ibanez- RG470, RG450, RG370DX

jsavage
Bottle Rocket
Posts: 1
Joined: Wed Dec 04, 2019 12:47 am

Re: Possible to 3D-Print Replacement Mark I-II-III-IV EQ Knobs?

Post by jsavage » Wed Dec 04, 2019 12:55 am

I don't know if there is any possible replacement to the 3d printer knobs, I have myself faced error while trying to replace the knobs and there was an unknown error called epson communication error, I have tried to counter it and had found the solution by switching the printer off for 30 seconds and then turning it on and then make the printer as a default, if this doesn't fix the issue, then reinstall the application and the software and the drivers to make things work.

Post Reply